Wide Application of Horizontal Washing Machine Used in Glass Industry

For the production of warm edge insulating glass (with flexible spacer, such as duralite or duraseal or superspacer), the cleaning requirements to the raw glass sheets are higher. Operators should ensure the good cleaning and drying for surface in order to conveniently make the spacer bonding for the following steps, meanwhile, avoiding surface scratch. For most developed countries and areas in the world, in order to make the entire warm edge I.G.U, more and more factories adopt horizontal washing machine. This kind cleaning equipment is composed of feeding section, washing section, drying section and output section and in the washing section, there are three tanks which feature of cycling heating water with the suitable PH (6-9), meanwhile, the machine must be installed with high quality rubber transfer rollers to avoid glass scratching. In addition, engineers should design special air knife structure applied in drying section of the washer, such as side-by-side multiple wind blade design, and guarantee the enough wind power and make it adjustable, as the best drying result, the air blower can blow hot air. All these considerations can achieve the excellent drying job: completely cleaning up or blowing off water in multi-angle and much area. Please also note that in order to match the total production line, the speed of glass washer also need to be regulated.

Remark: the production process of flexible spacer whirlpool 9.5 kg washing machine I.G. normally contains below machines: flat glass washing machine, flexible spacer assembly table, glass assembly table, heated roller press machine and glass convey table. Total production line has two-side or single side establishment. Glass is conveyed to glass washer in the horizontal state then starts its first process until to finish hot-press sealing job in heated roller machine. Around the production line, small assistant devices, such as gas filling machine, duraseal spool stand are also equipped.

(3).Cleaning application for coated glass

Before washing coating glass by the horizontal washing machine, we should take into account the choice of brush and water quality. In cleaning process, the coated glass sheets should not stop under brushes to avoid damaging the film. As the hardness of every brush may be different, we should also check the film after cleaning to confirm that if the brush do some damage on the surface of glass or not. When we clean the MSVD low-e coated glass, the best way is not to use recycled water, because these films are very sensitive to the PH value, if using recycled water, operators should monitor water PH value constantly.

Using demineralization or deionization water to spray coated glass to guarantee no residue when drying glass. However, the technology of this process may increase water corrosive, so we should test the sample water and confirm no adverse reactions occur. In addition, before large-scale production, we also should do some trial production to determine that if the water can work well in the system.

In real operation, solve the above problems, both horizontal glass washing machine and vertical glass washing machine can well complete cleaning and drying job to coated glass

As above glass features of large size, thickness and weight, factories often use horizontal washing machine to finish their cleaning job. For the vertical washer, because of its structural limitations, it can not suitable for washing large size glass. By means of choosing appropriate soft brushes and using different air knife structure, the horizontal glass washer can meet the washing and drying demand for above glass.